Construction of oil & gas refinery. My duties are fit up, alignment of pipe and other accessories of any elevation. Activities include Lay-out, cutting, and fabrications, mitered joints, pipe spools and pipe support. Construction of petro chemical complex. My duties are fit-up of spool on different pipe fitting, cutting and fabrications, mitered joints, fabrication and assembly of different pipe spools, erection and fit-up of different spools, installation of brackets, guide support and alignment. My duties are fabrication of pipe spools, installation of pipe fitting on different spool, erection & fit up of spools, installation of brackets, guide support and alignment of pipe and other accessories of any elevation.
With this society, I perform piping and put into commission activity for a refinement plant of the oil products in Midia Navodari. Confection, mounting and verification of the pipe line ( stainless steel , carbon steel ) , fittings ( flanges, elbows, tees…) and all type of valves ( screwed, flanged, welded), change of the damaged gasket, etc. In accordance with the piping diagram / layout for metallic pipes and fittings (measurement, marking, mechanical and gas cutting of the pipe section and metal profiles; rubbing, chamfering, drilling, points of weld, etc ) Confection of the all types of supports for the pipes, fittings and valves. Steel erector static equipment. Reconstruction of the unconformably metal structure for the static equipments. Also, with this society I made current revision at the heat excengers at the Rompetrol Midia Navodari / Kazakhstan Munay Gaz, performing all three pressure test in jacket , pipe with pipe and general.
Confection and mounting of the different types of flanged, screwed and welded pipelines, from 2 inch at 15 inch, in accordance with the piping isometrical. Measurement, marking, mechanical and gas cutting of the pipe section and metal profiles; rubbing, chamfering, drilling, points of weld, etc., which makes the connection with the water and gas pumps, compressors, heat exchanges, all types of the rotating and static equipments, at the different elevations, between 0 and 80 m. I mounted on pipes all the types of the flanges, elbows, T-s, nipoletes, weldoletes, elboletes and screwed and flanged valves - trimmed with complex gaskets, pipe porters for temperature maintenance. I made and placed weight supports at regular intervals, following a support spacing guide. I also performed the required pressure tests, hydrostatic and pneumatic tests. I made manufacture and montage of the platforms, laders, service walkways for access and assignment at the pipe lines and rotating and static equipments at the plant.